Rapid Engineering BH-40, Installation, Operation & Service Manual

Page: 17 / 68

SECTION 5: M
AJOR
C
OMPONENTS
11 of 59
SECTION 5: MAJOR COMPONENTS
FIGURE 13: Major Component Descriptions
Burner with Tube Gasket
M u st b e installed w ith the
flame o b ser v ation w indo w
facing do w n.
Reflector (Aluminum or
Stainless Steel)
Alternate o v erlap as sho w n on
o v er v ie w and on Page 17,
Figure 16 . Minim u m o v erlap is
6'' (16 cm).
Tube and Reflector Han g er
with Clamp Packa g e
Position this hanger no more
than 4” (10 cm) a
w ay from the
bu rner.
Couplin g Assembly with Lock
Reflector End Cap
P u nch o u t center section to
accommodate t ub e.
Tube and Reflector Han g er
S u spend system from these
hangers.
Flex Gas Line with
Shut Off Cock
Tube
Hot rolled or heat treated
al
u minized t ub e s u pplied in
10' (3 m) lengths.
Burner Tube
S u pplied in 10' (3 m) lengths.
B u rner t ub e is al w ays the first
t ub e after the bu rner.
Reflector Support Strap &
Wire Form
Turbulator
T u r bu lator m u st b e installed in the
last standard section of t ub e.
T u r bu lator is not req u ired on the
BH-125/150/175/200. For
installation,
see Page 21, Step 6.4
Vent Adapter