Operation manual - Spider ILD01
28 / 54
rev. 07-01-01-2010
9.9 PREPARING THE HETRONIC REMOTE RADIO CONTROLLER
Insert the battery (type 3,6V NiMh, 1200mAh) into the remote radio controller.
If LED flashes green, the battery is charged.
If the remote radio controller battery voltage is below the required level, the entire machine will turn off
automatically.
Discharge signal – if the voltage of the remote radio controller battery is too low, the colour of the LED on the
remote radio controller changes (LED flashes yellow). Move the mower to a safe place and replace the
battery. After the low voltage is indicated, you have about 10 minutes to move the mower to a safe place. After
10 minutes the remote radio controller will be turned off permanently. If the battery is exhausted, replace it with
a reserve battery
.
The tr ansmitter (r emote r adio controller) a nd th e r eceiver (c ontrol u nit) w ere a djusted a nd
set-up b y th e manufacturer. D o n ot m ake a ny m odifications to th ese d evices. T hey a re a
matched pair
.
9.10 CHARGING THEHETRONIC REMOTE RADIO CONTROLLER BATTERY
To charge the battery
:
Connect the charger to the electric power outlet in your car.
Insert the battery into the charger (LED CHARGE flasher for 2 seconds and then shines during charging).
Leave the battery in the charger as long as necessary (the charger controls the charge level and does not
overcharge the battery).
Fast charge – after connecting the battery press the FAST CHARGE button.
When the battery is fully charged, the green LED READY shines.
10 OPERATION
10.1 TRANSPORTING THE MOWER
The mower should be transported to the mowing area on a trailer or
other suitable transport vehicle.
Transporting the mower on thoroughfares on its own wheels is
prohibited
When loading/unloading a trailer, make sure that the edge - formed by
the floor of the trailer and the ramps – is not an obstacle for the mower.
Otherwise you need to use longer ramps.
When loading, do not allow any person to stand by the ramps or under
the hanging mower if it is lifted. It may only be hung up
on places marked by the chain symbol. The loading capacity of the
lifting eyes/ hooks must be suitable for the weight of
the machine as quoted on the serial plate.
After placing the mower on the transport, make sure it is properly
secured. Attach fastening devices to the eyes marked by the chain
symbol on the mower.
