MAINTENANCE
20
BELT TENSION CHECK
Belts have an automatic spring tensioner and need a check on the condition of springs.
To increase or decrease tension of belts proceed as follows:
•
Stop the machine.
•
Disengage the PTO shaft and
remove tractor ignition key.
•
Take off screws of the two
transmission covers, upper
and lower.
•
Remove the two covers.
•
Adjust on the nuts (A) of rod (B)
which is threaded to stretch or
extend the spring (C) with a power
of 20 lb. (9kg).
•
If the spring is slackened, it is
necessary to replace it; f rst it is
necessary to disassemble
the threaded rod.
•
Block the rod washers.
•
Reassemble the two transmission
covers and tighten the relevant screws.
SPARE PARTS ORDERING
To order spare parts, please see parts section in this catalog.
Request of spare parts must be made to a
Rankin
dealer and must always be complete with the following
information:
- Type and width of the implement.
- Part number of the needed spare part. If not in possession of this number, you can replace it
with the number of the table where the part is represented and the correspondent reference.
- Denomination of the needed part and desired quantity.