PM7000 Start Guide Issue 1 090608 7
Third Step:
Put your PM7000 on charge
Immediately you take delivery of your PM7000 plug it into the mains, using the mains lead or wall
charger, to charge the batteries ready for use.
Whenever your logger is in use, that is, attached to a voltage source above 90 Volts, the batteries
will be charging automatically. Outram Research highly recommend that at all other times the
logger is plugged into a power source to keep the batteries well charged and the unit always ready
for action. (This is merely a precaution. The PM7000 can start up with batteries pretty flat and
function once power is applied. There will soon be enough charge to allow any activity to be closed
down successfully and retained in memory.)
End Plate of PM7000 showing the two ends of the mains cable attached. Note the bottom row of
BNC connectors for the Rogowski coil current sensors.
Once the user interface screen is running, then taken directly from the initial screen is a status
screen to give you the current battery voltage should you wish to check.
Line
Return
12V charger input
