Ranger 2180 BAY RANGER, Owner'S Manual

Page: 33 / 78

Your Power Pedestals
YOUR POWER PEDESTALS
A “power pedestal” is a nitrogen gas filled steel cylinder that is used
to raise and lower the fishing seats mounted on the forward and aft
casting platforms. This enables you to select the proper seat height for
comfort in any fishing situation. Pushing the empty seats all the way
down helps to provide an unobstructed viewing area around the boat
when underway.
To raise the seat, simply lift your weight slightly off the seat while
raising the seat actuating lever simultaneously. To lower the seat, keep
your weight on the seat and lift the lever up.
These pedestals are constructed to the highest standard of
workmanship and will give years of trouble-free service. A minimum
amount of care will insure proper operation. Periodically apply a light
weight oil (like household “3 -in-1” oil) to the power unit piston. Take care
not to over stress the pedestal by placing excessive strain on the seat
and power unit while it is extended into the full up position. Always lower
the seat to the full down position when the boat is underway. We
recommend that the seat and pedestal be removed from the front
casting deck and remounted into the special base mounted in the front
of the deck floor when running. Should your boat not have the additional
base, the front fishing seat should be removed and securely placed in
the floor of the boat.
Your power pedestals are warranted for three years against defects
in materials and workmanship. Should a pedestal fail, return the unit to
Springfield Marine, Attention: Warranty/Repair, Hwy. 160, P.O. Box 588,
Nixa, Missouri 65714, or call 417-725-2667. Repairs not covered by
warranty will be charged at their regular rate.
If your power pedestal will not remain in position, either up or down,
you may need to make a minor adjustment to the air cylinder that
causes the pedestal to be raised up and down.
With your chair removed from the pedestal, use a Phillips #0
screwdriver to move the adjustment screw as shown in the
accompanying diagram.
33
Power unit is under pressure. Do not
attempt to disassemble it or tamper with
it in any way. Improper handling could result in severe injury or death.
WARNING
▲
!