Ranger 168, Owner'S Manual

Page: 53 / 77

Electrical System
FISHERMAN SERIES
Wake and Sleep Mode
Sleep mode will cause the keypad to reduce power consumption by
reducing live circuits. For the keypad to enter the sleep mode it will
require the main 30 amp breaker to be on, no switch activity for four
hours, all pumps turned off, and the ignition is off. When the keypad is in
the sleep mode the accessories will not function. To wake the keypad you
must press one of the following functions: Start, Stop, 1, 2, 3, 4, or any
button on the bow touch pad with the main breaker set to the on position.
After pressing one of the buttons, you can then proceed with your desired
operation. While the keypad is in the sleep mode, the float switch to the
bilge still has power and if the float switch is triggered, it will wake the
keypad. If the bilge pumps, livewell pumps or the ignition is left on, the
system will not enter sleep mode.
Keyless Ignition
Starting the engine:
• Turn the main breaker to on.
• Press on the buttons required to wake the system.
• Enter the following user code unless it has not been changed in order
“1-2-3-4”.
• Press “Start”. After pressing start the LED by the stop button will light
putting the keyless ignition switch in accessory mode.
• Press the “Start” button a second time holding it for two seconds and
the engine will crank.
• Once the engine has started, release the “Start” button.
• To stop the engine, press the stop button.
• To lock the system after stopping the engine, enter the user code “1-2-
3-4” and then press “Stop”.
To choke a carbureted engine:
Press the “Start” and the “1” key simultaneously while starting the
engine.
To change the user code:
Wake the system up by pressing one of the buttons described above.
Enter in the current user code followed by pressing the “1” and “4” buttons
at the same time. You will have two seconds after entering in the user
code to press the “1” and “4” buttons.
“1-2-3-4” buttons “1” and “4”
Leave the “1” and “4” depressed until the stop LED flashes. If the
stop LED does not flash after holding the “1” and “4” down for five
seconds, one of the following may have happened: the user code was not
entered correctly or “1” and “4” was not depressed at the same time, or
53