Rangemaster Toledo 90 Gas, User Manual

Page: 27 / 32

27
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
15. To Remove Fan Oven Inner Back.
Open RH oven door and remove the screws and
washers securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the 4 screws and washers are
fully tightened.
16 To Remove Tall Oven Door
Open oven door, support the door and remove the two
screws securing the upper hinge and packing to the
cooker front. Remove the door from the lower hinge by
lifting slightly and moving outwards.
Reassemble in reverse order.
17. To Change Tall Oven Door Outer Panel
Remove oven door see 16. Lay door face down on a
suitable surface and remove 2 screws from bottom edge
of door and 2 screws from inside face of door.
Remove outer door panel. Remove door handle by
unscrewing 2 screws. Remove 2 cross-headed screws
holding door handle fi xing bracket to door panel. Fit door
handle bracket and door handle to new panel.
Fit panel to door. Reassemble in reverse order.
18. To Change Tall Oven Door Magnetic Latch
Remove the control panel (see 4).
Remove the plinth (3 screws) and the central vertical
cover (5 screws). Prize the retaining clip off the magnet
unit. Fit new unit and retaining clip.
Reassemble in reverse order.
Check correct door operation.
19. To Change Fan in Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to
the fan noting their position. Remove oven inner back
(see 15).
Hold the fan blade and remove the centre nut (left hand
thread) 2 brass washers, fan blade and circlip. Unscrew
fan retaining nuts and washers (3 off each) and lift the
fan away from the rear of the cooker. Fit new fan and
reassemble in reverse order. Check operation of oven
20. To Remove Fan Oven Element.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected
to the element noting their position. Remove oven
inner back (see 15). Remove 2 screws from the top
of the element and 1 from the bottom of the element
in side the oven. Lift out carefully, refi t new element,
reassemble in reverse order. Check operation of oven.
21. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from
grill roof, 2 screws and washers. Remove 2 screws
and washers securing the grill element front support.
Remove the screws from the grill elements.
Lift elements out carefully, disconnect the leads from
the element terminals noting their position. If it is not
possible to disconnect the leads in this way, pull cooker
forward to gain access to the rear, remove screws
securing the electric cover to the back sheet and
remove cover and disconnect the terminals from the
rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.