Rangemaster Excel FSD, Users Manual & Installation

Page: 20 / 44

20
To fi t the small inner burner, fi nd the larger electrode
notch in the burner rim. Line this up with the white
ignition electrode and place the inner burner on the
large base ring.
A electrode notch B ignition electrode
Now fi t the two burner caps, making sure that they
are sitting down properly.
Ceramic Hob
It’s very easy to clean the Hob with a recommended
cleaner.
CAUTION — Do not use abrasive cleaners or pads,
oven aerosols or pads or stain removers on the
surface.
Daily care
First of all, be sure that the heat indicator light is
off and the cooking surface is cool. Apply a small
dab, about the size of a 10p piece, of ceramic cooker
cleaning cream in the centre of the area to be
cleaned. Dampen a clean paper towel and work the
cleaning cream on the cooking surface as if you were
cleaning a window. As a fi nal step, wipe the cooking
surface with a clean, dry paper towel.
Cleaning for spills
For spills and boil-overs that occur while cooking,
turn the unit off and wipe the area surrounding the
hot zone with a clean paper towel. If a spill (other
than a sugary substance) is on the hot zone, do
not clean until the unit is completely cooled down
and follow the instructions below (“Cleaning for
burned-on spills”). If you accidentally melt anything
on the cooking or if you spill foods with a high sugar
content (preserves, tomato sauce, etc.), REMOVE the
spill IMMEDIATELY with a razor scraper, while the
hob is still hot. IMPORTANT: Use an oven glove to
protect your hand from potential burns. Scrape the
major spill or melted material from the cooking zone
and push into a cold area. Then, turn the unit “OFF”
and allow to cool before cleaning further. After the
cooking surface cools down and the heat indicator
lights go off , use the daily care procedure.
Cleaning for burned-on spills
Be sure that the heat indicator lights are off and the
hob is cool. Remove excess burned-on substance
with a single-edged razor scraper. Hold the scraper at
approximately a 30° angle to the surface and scrape
off the burned-on matter as you would scrape paint
off of a window.
IMPORTANT: Take care when using a sharp scraper.
When you have removed as much as possible with
the scraper, clean using the daily care procedure as
described above.
To remove metal rub-off
Sliding pans on the hob - especially aluminium or
copper pans can leave marks on the surface. These
marks often appear like scratches, but can be easily
removed using the procedure described above for
cleaning spills. If the rub-off marks are especially
stubborn, use the cleaning cream together with the
razor scraper, using the technique described above.
Grill
The grill pan and grid should be washed in hot soapy
water. After grilling meats or any foods that soil, leave
to soak for a few minutes in the sink immediately
after use. Stubborn particles may be removed from
the grid by using a nylon brush. Alternatively the grill
pan can be washed in a dish washer.
To remove the grill pan support frame, pull the grill
pan forward.