Rangemaster Elise 110 Dual Fuel, User'S Manual & Installation Instructions

Page: 24 / 36

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
20
130 mm minimum
ArtNo.110-0066 - 110DF - Elise SE min spacings
0
100
1 4
0
180
0
1
2
3 3
2
1
220
0 0 0 0 0 0 0
100
140
180
220
0
75 mm
min
75 mm
min
650 mm
min
910 mm
min
930 mm
max
Fig.7-1
Fig.7-3
ArtNo.110-0064 - 110DF - Elise min positions above cooker
0
100
14
0
180
0
1
2
3 3
2
1
220
0 0 0 0 0 0 0
100
140
180
220
0
410 mm min
1100 mm min*
**
Fig.7-2
Positioning the Cooker
Fig.7-1 and Fig.7-2 show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
Above hotplate surround should be level with, or above, any
adjacent work surface.
A gap of 75 mm should be left between each side of the
cooker
ABOVE
the hotplate level and any adjacent vertical
surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles), this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of
the hotplate and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer’s instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for the
additional height of the flue trim, which is fitted to the cooker
hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration.
We cannot accept responsibility for damage caused by
normal use of the cooker to any material that de-laminates
or discolours at temperatures less than 65 °C above room
temperature
Do not box the cooker in – it must be possible to move the
cooker in and out for cleaning and servicing.
If the cooker is near a corner of the kitchen, a clearance of
130 mm is required to allow the oven doors to open (Fig.7-3) .
The actual opening of the doors is slightly less but this allows
for some protection of your hand as you open the door.
When Fitting Between Kitchen Cabinets
We recommend that you either:
A.
Fit the cooker so that any cabinet doors are at least
30 mm behind the cooker door fronts. Note that this
may require an infill piece behind the cooker.
We recommend a gap of 1110 mm between units to
allow for moving the cooker.
B.
Leave a gap of at least 14 mm on either side of the
cooker (a 1120 mm gap between units). The cooker
should be positioned centrally.
We also recommend that you do not final fix any adjacent
cabinets until the cooker is installed. Decorative mouldings
or handles on cabinet doors and fronts may interfere with the
opening of the oven doors.
Fig.7-4