Rangemaster EDL100DFF, User'S Manual & Installation Instructions

Page: 32 / 48

28
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
ArtNo.110-0004 - 110 Cooker min spacings
5 mm 5 mm
Height to Hotplate
905 mm min
930 mm max
Height to Flue Trim
920 mm min
945 mm max
650 mm min
410 mm min 410 mm min
Wall Wall
1004 mm
75 mm min 75 mm min
check cookerhood instructions for actual dimensions
994 mm
Positioning the Cooker
Fig. 9.1
and
Fig. 9.2
shows the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
Fig. 9.1
and
Fig. 9.2
Cookers installed into recess: The cooker
must have side clearance
ABOVE
hob level of 75mm up to a
height of 410mm. This can be reduced to 25mm if the surface
of the side wall is non-combustible.
A minimum space of 650 mm is required between the top of
the hob and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer’s instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for the
additional height of the flue trim, which is fitted to the cooker
hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
cooker to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
DO NOT box the cooker in – it must be possible to move the
cooker in and out for cleaning and servicing.
To allow the oven doors to open, a clearance of 130 mm is
required if the cooker is near a corner of the kitchen (
Fig. 9.3
).
The actual opening of the doors is slightly less, but this allows
for some protection of your hand as you open the door.
Moving the Cooker
n
On no account try and move the cooker while it is
plugged into the electricity supply.
n
The cooker is very heavy, so take great care.
We recommend that two people manoeuvre the cooker.
Make sure that the floor covering is firmly fixed, or removed,
to prevent it being disturbed when moving the cooker
around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt
the cooker backwards and remove the front half of the
polystyrene base (
Fig. 9.4
).
Repeat from the back and remove the rear half of the
polystyrene base.
ArtNo.000-0013 90 Door clearances
130 mm min
ArtNo.090-0010 - 100 2BC cooker min spacings
75mm
min
75mm
min
650mm
min
902mm min
929mm max
Fig. 9.1
Fig. 9.2
Fig. 9.3
Fig. 9.4