10
Always disconnect the appliance from the
electricity mains before making any
adjustments. All seals must be replaced by
the technician at the end of any adjustments.
The burners do not require primary air
adjustment.
9) TAPS
The gas taps are male conical type, suitable for all
gases.
“Reduced rate” adjustment
- Light the burner and turn to the "Reduced rate"
position (small flame fig. 1).
- Pull off the control knob "M" (fig. 12).
- Insert a small screwdriver "D" into the hole "C"
(fig. 12) and turn the throttle screw to the right or
left to adjust the reduced rate. Check that the
flame does not go out when the knob is sharply
turned from the "Full on" to the "Reduced rate"
position.
This adjustment only applies to only burners
operating on Natural gas. The screw must be
fully locked in when the burners operate with
LPG.
FIG. 12
ADJUSTMENTS
Summary of Contents for 58580
Page 16: ...16 V I...
