back
set
(
60 or 70 mm
)
(
35 mm to 50 mm)
A
A
B
B
C
D
1"
(25 mm)
1
Prepare the door and check dimensions
Measure to confirm that the hole in the
door is 2-1/8" (54 mm)
Measure to confirm that the backset is
either 2-3/8" or 2-3/4" (60 or 70 mm)
Measure to confirm that the the hole in
the door edge is 1" (25 mm)
Measure to confirm that the door is
1-3/8" to 2" (35 mm or 50 mm)thick
2
Install the latch and strike
B
A
Is the door edge chiseled?
Is the slotted hole centered in the door hole?
Hold the latch in front of the door hole, with the
latch face flush against the door edge
YES
YES
NO
NO
Make sure
the UP icon
goes up.
Install latch in door with
screws I.
Do not overtighten screws.
No adjustment is
required. Proceed
to next step.
Slotted hole is
centered.
Slotted hole is
NOT centered.
Rotate and pull the
latch as shown to
extend latch.
chiseled
not
chiseled
I
or
or
1 / 6
Use a flathead screwdriver to
remove Rectangular face
from latch and install drive-in
collar.
2-3/8" or 2-3/4"
1-3/8" to 2"
(54 mm)
2-1/8"
1
φ
2-3/4”
(70mm)
2
1
2
3
4
C
IMPORTANT:
Make sure hole in door frame is drilled a
minimum of 1" (25 mm) deep.
H
C
Install strike with screws H on the door frame
Install latch in door with
wood block and hammer.
Latch
Exterior Assembly
Battery Cover
Strike
A
E
K
×3
F
G
B
C
D
Parts List
If any parts are missing or damaged, please
reach out to us.
Drive-In Collar
(Optional)
Strike Screws
Latch Screws
Mounting Plate
Interior Assembly
Screws
Interior
Assembly
Mounting Plate
Screws
L
×1
Backup Key
H
×2
I
×2
J
×2
I
H
J
C
K
E
G
F
D
L
A
TOOL REQUIRED:
USE OF A POWERED SECREWDRIVER IS
NOT RECOMMENDED
With the door closed, use a flat-head
screwdriver to test if deadbolt works
smoothly.
Check alignment between the latch and the
strike, making sure when the deadbolt is
extended, it is going into the bolt hole and not
hitting the deadbolt strike or door frame.
D
(Optional)
