Subject to modifications
-- page 1 --
SELO-B-Standard-Betriebsanleitung-englisch.p65
Date: 03.05
Operating instructions - Basic functions
of electronic lock SELO-B (Version 1.0)
Electronic lock model SELO-B allows you to open the lock either immediately, after entering the valid 7- or 8-digit secret
code, or after expiration of a preset opening delay. The lock’s time functions can be set such that access is only granted
at the preselected times. The maximum number of codes for clearing the lock is 40.
A) GENERAL
- The opening procedure consists of two operations: CLEARING and UNBLOCKING.
- To start the opening procedure, check that the input unit is in the vertical end position.
- All accepted key strokes will produce a response on the display.
- If the code number is keyed in by mistake, return to the starting position of the lock by pressing the
On/Enter
key, and start over.
- After entering the wrong secret code three times in a row, the lock will automatically block all further entries
for 5 minutes. If, after waiting for 5 minutes, the wrong code is entered again, the lock will block itself for a
further 20 minutes (manipulation resistance). During this time, the remaining delay is depicted on the display
and not even the valid number code will open the lock.
- If more than 30 seconds lapse between pressing any two keys, the lock automatically switches itself off for safety
reasons. The opening procedure has to be started over.
- Once data have been stored (numerical codes, time frame and user entries), not even a power failure will delete
them.
3 lines for entering codes and
displaying messages
1 line for displaying battery
condition and key functions
Function key for correcting data
input and selecting menu
functions
On/Enter-key to switch on the
unit, select functions and to set
the lock to its starting position
Rotary handle for unblocking
the lock
Multifunction keys „1“ and „2“
for entering figures and words,
and for menue navigation
Keys „0“ - „9“ for entering
numbers and plain text
- Battery condition 1/3
- Key marked „Function“ to
return to next higher menu
level
- Keys „1„ and „2“ to
navigate through the menu
- Battery condition „full“
- Key marked „Function“ to
select the desired menu
from the setting mode
- Battery condition 2/3
- Key marked „Function“ for
deleting the figure entered
last
- Battery condition „almost
empty"
