Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
RR602 Trailer
Assembly Manual
1.)
Unpack all pieces from the tub & crate, empty bag with nuts, bolts and pins onto a flat surface.
2.)
Find the main frame, lay it down with axle tabs facing up.
3.)
Place the walking beams between the tabs on either side. The holes drilled in the walking beams are
offset, therefore one end is slightly longer than the other. The short end of the walking beam will be
facing the rear of the trailer. The front of the trailer has the bolt holes drilled on the side- as seen in
the photo below. Install the large swivel pins, install the small bolts into the plate on the large swivel
pins and install cotter pins on the backside. Grease both swivel pins