Range Road RR560, Operator'S Manual

Page: 17 / 24

2.
2.
4.
3.
5.
3.
1.
1.
Tightening Tracks
With use, tracks tend to loosen. When
operating with loose tracks, they tend to slip
over the driving wheel causing it to jump its
housing, thus damaging wear to the housing.
To check track tightness, proceed as follows.
If the distance is greater, proceed as follows.
Use the tipping handle to tip the hopper
and set it on blocks or supports rated for
the weight of the box.
Loosen locknut A.
Tighten bolt B until the correct tightness is
restored.
Secure bolt B by tightening locknut A
thoroughly.
Return the hopper to its original position.
Measure the track midline vs. the horizontal
line. The reading must not be more than
10cm~15cm.
Set the machine on a flat surface with
compact ground, or on asphalt or pavement.
Lift the machine and set it on blocks or
supports rated for the weight of the machine
so that the tracks are approximately 4” off
the ground.
10cm ~ 15cm
Adjusting Bolt
A
B
A
B
Jam Nut
MINI TRACKED DUMPER
17
GB
Do not over-tighten your track.
The adjustment of the track and
the brakes are linked. The braking
power will lessen the more the track
is tightened.
If the adjustment bolt has no more
adjustment left, the tracks may have
to be replaced.
Steering Wheel Axle
Steering Wheel