14
Grill
The grill pan and trivet should be washed in hot soapy water.
Alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for a
few minutes immediately after use. Stubborn particles may
be removed from the trivet using a nylon brush.
nn
Before you remove any of the grill parts for cleaning,
make sure that they are cool, or use oven gloves.
n
n
DO NOT use any abrasive substances.
Control Panel, Doors and Glass Lid
Avoid using any abrasive cleaners including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can be used on the doors, or alternatively,
using a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. After
cleaning, polish with a dry cloth.
n
n
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean the glass lid since they can scratch
the surface, which may result in shattering of the
glass.
Glass Fronted Door Panels
The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the
‘Moving the Cooker’
section under
‘Installation’
).
Open the oven door slightly and remove the front panel
fixing screws from the door sides, two each side
(Fig.5.5)
.
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
Note:
If the door is triple glazed then the inner two panels are
fixed together and should not be separated.
After cleaning, carefully refit the outer door panel and replace
the side fixing screws.
nn
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.
Ovens
‘Cook & Clean’ Panels
The ovens have panels which have been coated with a special
enamel that partly cleans itself. This does not stop all marks
on the lining, but helps to reduce the amount of manual
cleaning needed. The ‘Cook & Clean’ panels work better
above 200 °C. If you do most of your cooking below this
temperature, occasionally remove the panels and wipe with a
lint free cloth and hot soapy water. The panels should then be
dried and replaced and the oven heated at 200 °C for about
one hour. This will make sure the ‘Cook & Clean’ panels are
working effectively.
ArtNo.320-0002a Proplus oven door side screws
Fig.5.5
Fig.5.6
