4
1. Assemble the Platter System
1.
Remove the Twelve MKII base from the packaging. Remove the
platter assembly from the package (underneath Twelve MKII). Place
Twelve MKII on a flat, stable surface for assembly and operation.
2.
Place the platter onto the Twelve MKII base by aligning the pins in the
bottom of the platter with the holes in Twelve MKII’s motor. Press it
down firmly. Check to make sure that it rotates uniformly and does not
wobble excessively.
3.
Place the slipmat onto the platter. Then place the
Control Disc
over
the spindle (with the attached
Quick Release Adapter
on top). To
lock the
Control Disc
to the spindle, pinch the top of the spindle while
slowly rotating the disc until you hear it click. It locks when the groove
in the spindle lines up directly opposite to the button on the side of
the
Quick Release Adapter
.
Note:
If you would like to adjust the slip friction of the disc, consider
placing 1-4 of the included spacers over the spindle, underneath the
slipmat. The more you elevate the
Control Disc
with the spacers, the
more spinback you will get.
2. Connect and Start DJing!
1.
Make sure you have downloaded and installed the latest version of your DJ software.
2.
Place Twelve MKII on a flat, stable surface.
3.
While the power is switched off, plug the included power cable into Twelve MKII first, then
plug the cable into a power outlet.
4.
Power on Twelve MKII using the
power switch
.
5.
Use a standard USB cable (included) to connect the
USB Port
to one of the following:
•
If you are using Twelve MKII with the Rane Seventy-Two mixer (sold separately),
connect the USB cable to the
Deck 1
or
Deck 2
USB ports labeled
Twelve MKII/
Controller
.
•
If you are using another mixing interface, connect the USB cable to an available
USB port on your computer or a powered hub connected to the computer.
6.
Alternatively, connect standard RCA stereo cables from the
Audio Output
to the input of a
compatible mixer or other DVS-enabled device for timecode control.
7.
Open Serato DJ Pro. The Twelve MKII works with Serato DJ Pro using two modes:
•
Serato USB:
This mode is identical to the operation of the original Rane Twelve, where
the software is controlled through a USB connection. When using this mode, the
software should be set to
Internal Mode
.
•
Serato DVS:
This mode will send DVS audio signal through the
Audio Out (RCA)
ports
to control the platter. When using this mode, the software should be set to
Relative
Mode
.
It is recommended to connect your Twelve MKII using both the Audio Out (RCA) ports (for
DVS platter control) and USB (for MIDI controls such as Browse, Load/Instant Doubles,
Hot Cues, etc.).
For more information on how to use Serato DJ Pro with the Twelve MKII, please visit
.
