OWNER’S MANUAL
11
SIXTY-ONE
Sixty-One Connections
Power Supply
This mixer features an internal universal switching power supply that operates on any AC mains 100 to
240 VAC, 50 or 60 Hz (most places in the world). The universal supply is a major plus for the traveling DJ,
who only needs the right IEC line cord, available from a local electronics store. Though this mixer has turn
on/off muting, it’s smart to leave the power unplugged until everything else is connected.
Analog Inputs
Four Phono / CD inputs are provided by RCA jacks. These may be set for PH or CD using rear panel slide
switches. Analog inputs 1 and 2 are used by the
DECK 1
controls. Analog inputs 3 and 4 are used by the
DECK 2
controls. Analog input 1 or 2 may be selected in Serato DJ software (Audio tab in the Setup screen)
as the Digital Vinyl Simulation (DVS) signal for the Left Virtual Deck or for recording on USB stereo pair
5-6. Analog input 3 or 4 may be selected in software as the DVS signal for the Right Virtual Deck or for
recording on USB stereo pair 7-8. Set any unused inputs to CD. Connect your turntable ground wires to
the ground posts provided on the rear panel when using PH inputs.
One stereo Session Input is available on a pair of RCA jacks. This input may connect two mixers
together, or as a general purpose line-level auxiliary input.
The Mic Input will accept an XLR 3-pin plug, a balanced ¼˝ TRS (tip-ring-sleeve) plug or an unbalanced
¼˝ TS (tip-sleeve) plug. This input may be set for Microphone or Line level using the Mic / Line switch on
the rear panel. Set this to
LINE
when connecting a wireless receiver.
A stereo FlexFx Loop Return input is from a pair of unbalanced ¼˝ TS jacks. These inputs are
automatically configured for mono when only one cable is connected to the Left or Right Return input.
The FlexFx Return input is normally used in conjunction with the FlexFx Send output to connect an
outboard analog effects processor.
Analog Outputs
There are four stereo analog outputs on the mixer:
•
Main Out
is on a pair of balanced ¼˝ TRS (tip-ring-sleeve) jacks.
•
Session Out
is on a pair of unbalanced RCA jacks.
•
FlexFx Loop Send
output is on a pair of unbalanced ¼˝ inch TS (tip-sleeve) jacks. For a mono FlexFx
Send, use the
Left
output. The FlexFx Send output is normally used in conjunction with the FlexFx Loop
Return input to connect outboard effects.
•
Headphones
output is available on both ¼˝ and 3.5 mm jacks.
The Main and Session outputs come from the same “Main Mix” signal. Main and Session outputs each
have their own Level control. Because these signals are identical, you may use either of these outputs as
the “Main” output if the other cable type is required for system connection. That said, Rane recommends
¼˝ TRS (tip-ring-sleeve) cables for the strongest signal and rejection of hum and noise. If your cable to
the amplifiers are less than 10 feet (3 meters), you can often get away with an unbalanced cable. See the
RaneNote “
Sound System Interconnection
” at rane.com for cable wiring recommendations.
MAIN OUT
PHONO
GROUNDS
ANALOG INPUT SELECT
SESSION
100-240V 50/60 Hz 15 WATTS
MADE IN U.S.A. RANE CORP.
FLEXFX LOOP
USB
OUT
IN
2
1
4
3
2
1
4
3
PH CD PH CD
PH CD PH CD
MIC LINE
MIC INPUT
ACN 001
345 482