Remote Commands
R&S
®
ZNH
248
User Manual 1334.5985.02 ─ 02
[SENSe:]BWIDth[:RESolution]:AUTO
<State>
[SENSe:]BANDwidth[:RESolution]:AUTO
<State>
This command couples and decouples the resolution bandwidth to the span.
Parameters:
<State>
ON | OFF
*RST:
ON
Example:
BAND:AUTO OFF
Decouples the resolution bandwidth from the span.
12.6.3.4
Performing Measurements
The following commands control the actual measurement process.
List of commands
.................................................................................................248
INITiate:CONTinuous
<State>
This command selects the sweep mode.
Parameters:
<State>
ON | OFF
ON
Selects continuous sweeps.
OFF
Selects single sweep.
*RST:
ON
Example:
INIT:CONT OFF
Turns on single sweep mode.
[SENSe:]SWEep:POINts
<NrofPoints>
This command queries the number of measurement points in a single sweep.
This command is a query and therefore has no *RST value.
Parameters:
<NrofPoints>
Returns the number of sweep points.
Example:
SWE:POIN?
Returns the number of sweep points.
12.6.3.5
Working with Traces
The following commands set up the trace and the various functions associated with it,
e.g. trace mathematics or the selection of the detector.
Remote Control - Commands
