Remote-Control Commands
Satellite Navigation
386
User Manual 1178.6379.02 ─ 01
Example:
See
Chapter 19.17, "Trigger Settings"
Manual operation:
See
"External Delay/Trigger Delay"
[:SOURce<hw>]:BB:GNSS:TRIGger[:EXTernal]:INHibit
<Inhibit>
Specifies the number of chips by which a restart is to be inhibited following an external
trigger event.
Parameters:
<Inhibit>
integer
Range:
0 to 67108863
*RST:
0
Example:
See
Chapter 19.17, "Trigger Settings"
Manual operation:
See
"External Inhibit/Trigger Inhibit"
19.18 Marker Settings
Example: Configure and enable standard marker signals
SOURce:BB:GNSS:TRIGger:OUTPut2:MODE?
// RESTart
SOURce:BB:GNSS:TRIGger:OUTPut2:FOFFset 10
SOURce:BB:GNSS:TRIGger:OUTPut2:ROFFset 20
SOURce:BB:GNSS:TRIGger:OUTPut3:DELay 16
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:MODE
..................................................386
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:ONTime
............................................... 387
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:OFFTime
..............................................387
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PATTern
...............................................387
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:DIVider
......................................387
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:FREQuency?
.............................387
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:PULSe:WIDTh
...................................... 388
[:SOURce<hw>]:BB:GNSS:TRIGger:OUTPut<ch>:MODE
<Mode>
Defines the signal for the selected marker output.
Parameters:
<Mode>
PULSe | PATTern | RATio | PPS | PP2S | TRIGger | DISabled |
RESTart | PPS10
*RST:
PPS
Example:
See
Chapter 19.17, "Trigger Settings"
Manual operation:
See
Marker Settings