Instrument Function
R&S
®
SMB100A
106
Operating Manual 1407.0806.32 ─ 21
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup
Address Mode
Selects the mode for assigning the IP address.
"Auto (DHCP)" Assigns the IP address automatically, provided the network supports
DHCP (
D
ynamic
H
ost
C
onfiguration
P
rotocol)
The network used must support automatic assignment of the IP
address via DHCP or APIPA (Zeroconf) in order to use this function.
"Static"
Enables you to assign the IP address manually.
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress:MODE
IP Address
Displays the IP address.
By default, the R&S
SMB is configured to use dynamic TCP/IP configuration and to
obtain the whole address information automatically.
If the network does not support DHCP or the attempt does not succeed, the instrument
tries to obtain the IP address via Zeroconf (APIPA) protocol. IP addresses assigned via
Zeroconf start with the number blocks
169.254.*.*
.
Note:
An IP address that is assigned via the Zeroconf protocol while the network
requires an IP address assigned via the DHCP server may cause network connection
failures.
See
Chapter 9.5, "Resolving Network Connection Failures"
To assign the IP address manually, select
Remote command:
:SYSTem:COMMunicate:NETWork:IPADdress
Subnet Mask
Displays the bit group of the subnet in the host identifier.
To assign the subnet mask manually, select
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK
Default Gateway
Displays the gateway address.
To assign the gateway address manually, select
"Static".
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway
DNS Suffix
Displays the primary DNS (
D
omain
N
ame
S
ystem) suffix, that means the DNS name
without the host name part.
General Instrument Settings
