R&S SMA100B, User Manual

Page: 380 / 581

Remote Control Commands
R&S
®
SMA100B
365 User Manual 1178.3834.02 ─ 03
● SOURce:PGEN Subsystem ..................................................................................431
● SOURce:PHASe Subsystem ................................................................................ 432
● SOURce:POWer Subsystem ................................................................................ 433
● SOURce:ROSCillator Subsystem ......................................................................... 442
● SOURce:SWEep Subsystem ................................................................................447
12.15.1 Analog Modulation Subsystems
Option: see Chapter 4.1, "Required Options" , on page 74.
The subsystems in this section describe all commands for analog modulation of the RF
signal. Divided in separate sections, you can configure amplitude modulation (AM), fre-
quency modulation (FM) , phase modulation (PhiM) and pulse modulation (PULM).
You can perform each of the modulations either with an internally generated modula-
tion signal or with an externally applied signal.
To configure the internal signal, use the commands listed in Chapter 12.15.5,
"SOURce:LFOutput Subsystem" , on page 403.
For more information:
See Chapter 4, "Analog Modulations" , on page 74.
12.15.1.1 SOURce:MODulation Subsystem
The command in this subsytem allows you to disable all active modulations at once,
and, vice versa, to restore the last active ones.
[:SOURce<hw>]:MODulation[:ALL][:STATe] <State>
Activates all modulations that were active before the last switching off.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
SOURce Subsystem