R&S SGT100A, User Manual

Page: 345 / 593

Remote Control Commands
R&S
®
SGT100A
314 User Manual 1176.8674.02 ─ 07
Usage: Query only
Manual operation: See "Measured External Clock" on page 122
:CLOCk:INPut:SLOPe <Slope>
The command sets the active slope of an externally applied clock signal at the USER
1/2 connector.
Parameters:
<Slope> NEGative | POSitive
*RST:
POSitive
Example: CLOC:INP:SLOP NEG
The active slope of the external clock signal is the falling slope.
:CLOCk:OUTPut:MODE <Mode>
The command sets the output of bit or symbol clock pulses at the USER 1/2 connector
at the rear panel.
Parameters:
<Mode> SYMBol | BIT
*RST:
SYMBol
Example: CLOC:OUTP:MODE SYMB
The internal symbol clock is output.
11.6 CONNector Subsystem
:CONNector:REFLo:OUTPut
........................................................................................... 314
:CONNector:USER<ch>:OMODe
.....................................................................................315
:CONNector:USER<ch>:THReshold
................................................................................ 315
:CONNector:USER<ch>:CLOCk:IMPedance
.....................................................................316
:CONNector:USER<ch>:TRIGger:IMPedance
...................................................................316
:CONNector:USER<ch>:CLOCk:SLOPe
...........................................................................316
:CONNector:USER<ch>:TRIGger:SLOPe
.........................................................................316
:CONNector:REFLo:OUTPut <Output>
Determines the signal provided at the output connector REF/LO OUT (rear of the
instrument).
Parameters:
<Output> REF | LO | OFF
*RST:
REF
Manual operation: See "REF/LO Output" on page 202
CONNector Subsystem