Remote control commands
R&S
®
RTO6
1492
User Manual 1801.6687.02 ─ 05
<MeasType>
parameter value
(remote control)
Measurement
(manual opera-
tion)
Description, result
Suffix
<n>
SLEFalling
Slew rate on fall-
ing edge
Steepness of the falling edge: voltage difference
between the higher and lower reference level, divided by
the fall time.
49
ATAR
Arithmetic for
amplitude/time
measurements
Basic arithmetic calculations with measurement values
and scalars.
50
...................................................................................... 1492
.................................................................................1493
............................................................................ 1493
MEASurement<m>:AMPTime:PFSLope
......................................................................... 1493
........................................................................... 1494
MEASurement<m>:AMPTime:DELay<n>:DIRection
........................................................ 1494
MEASurement<m>:AMPTime:DELay<n>:ECOunt
........................................................... 1495
MEASurement<m>:AMPTime:DELay<n>:LSELect
.......................................................... 1495
MEASurement<m>:AMPTime:DELay<n>:SLOPe
............................................................ 1495
MEASurement<m>:AMPTime:PTCount
.......................................................................... 1496
........................................................................... 1496
........................................................................... 1496
MEASurement<m>:AMPTime:CLCK<n>:LSELect
........................................................... 1497
MEASurement<m>:AMPTime:DATA<n>:LSELect
............................................................1497
MEASurement<m>:AMPTime:DTOTrigger<n>:SLOPe
..................................................... 1497
MEASurement<m>:AMPTime:DTOTrigger<n>:LSELect
................................................... 1498
MEASurement<m>:AMPTime:LCHeck<n>:VALid
............................................................ 1498
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:LIMit
...................................................1499
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:LIMit
................................................... 1499
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin
............................................. 1499
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:MARGin
.............................................. 1499
MEASurement<m>:ENVSelect
<EnvelopeCurve>
The command is only relevant for measurements on envelope waveforms. It selects
the envelope to be used for measurement.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
Parameters:
<EnvelopeCurve>
MIN | MAX | BOTH
MIN: measures on the lower envelope
MAX: measures on the upper envelope
BOTH: the envelope is ignored and the waveform measured as
usual
*RST:
BOTH
Usage:
Asynchronous command
Automatic measurements