Browser-Based User Interface
R&S
®
NRPxxS(N)
49
User Manual 1177.5079.02 ─ 10
6.5.1
Sensor Settings
Describes the parameters for optimizing the measurement results for specific measure-
ment requirements.
Further information:
●
Chapter 9.4.2, "Selecting a Measurement Path"
,
on page 70
●
Chapter 9.8.4, "Configuring Corrections"
,
on page 110
●
Chapter 9.9, "Calibrating/Zeroing the Power Sensor "
,
on page 125
●
Chapter 9.10, "Testing the Power Sensor"
,
on page 127
Access: main dialog of the web user interface > navigation pane > "Sensor"
Range
............................................................................................................................49
Γ Correction
...................................................................................................................49
└
<State>
........................................................................................................... 49
└
Magnitude
....................................................................................................... 49
└
Phase
..............................................................................................................50
Zero Calibration
.............................................................................................................50
Diagnostics
....................................................................................................................50
Range
Selects which path of the sensor is used for the measurement.
Remote command:
[SENSe<Sensor>:]RANGe:AUTO
on page 71
[SENSe<Sensor>:]RANGe
on page 71
Γ Correction
Groups the parameters for the complex reflection coefficient. See also
Chapter 9.8.4.4,
"S-Gamma Corrections"
,
on page 113.
<State> ← Γ Correction
Enables or disables the use of the complex reflection coefficient of the signal source,
Γ
source
.
Remote command:
[SENSe<Sensor>:]SGAMma:CORRection:STATe
on page 114
Magnitude ← Γ Correction
Sets the magnitude of the complex reflection coefficient of the source ,
Γ
source
.
Settings