R&S FSW-K7, User Manual

Page: 294 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
294 User Manual 1173.9240.02 ─ 23
11.5 Capturing Data and Performing Sweeps
MSRA/MSRT operating mode
Note that in MSRA/MSRT operating mode, capturing data is only possible for the
MSRA/MSRT Master channel. In Analog Demodulation application channels, the
sweep configuration commands define the
analysis interval . Be sure to select the cor-
rect measurement channel before using these commands.
ABORt
.......................................................................................................................... 294
INITiate<n>:CONMeas
................................................................................................... 295
INITiate<n>:CONTinuous
................................................................................................295
INITiate<n>[:IMMediate]
..................................................................................................296
INITiate<n>:REFResh
.................................................................................................... 296
INITiate<n>:SEQuencer:ABORt
.......................................................................................297
INITiate<n>:SEQuencer:IMMediate
..................................................................................297
INITiate<n>:SEQuencer:MODE
....................................................................................... 298
INITiate<n>:SEQuencer:REFResh[:ALL]
.......................................................................... 298
SYSTem:SEQuencer
......................................................................................................299
ABORt
This command aborts the measurement in the current measurement channel and
resets the trigger system.
To prevent overlapping execution of the subsequent command before the measure-
ment has been aborted successfully, use the
*OPC?
or
*WAI
command after
ABOR
and
before the next command.
For details see the "Remote Basics" chapter in the R&S FSW User Manual.
To abort a sequence of measurements by the Sequencer, use the
INITiate<n>:
SEQuencer:ABORt
command.
Note on blocked remote control programs :
If a sequential command cannot be completed, for example because a triggered sweep
never receives a trigger, the remote control program will never finish and the remote
channel to the R&S
FSW is blocked for further commands. In this case, you must inter-
rupt processing on the remote channel first in order to abort the measurement.
To do so, send a "Device Clear" command from the control instrument to the
R&S
FSW on a parallel channel to clear all currently active remote channels. Depend-
ing on the used interface and protocol, send the following commands:
●
Visa :
viClear()
●
GPIB :
ibclr()
●
RSIB :
RSDLLibclr()
Now you can send the
ABORt
command on the remote channel performing the mea-
surement.
Capturing Data and Performing Sweeps