R&S FSW-K7, User Manual

Page: 193 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
193 User Manual 1173.9240.02 ─ 23
Manual operation: See "Bias Settings" on page 60
[SENSe:]MIXer:BIAS[:LOW] <BiasSetting>
This command defines the bias current for the low (first) range.
This command is only available if the external mixer is active (see
[SENSe:]MIXer[:
STATe]
on page 192).
Parameters:
<BiasSetting> *RST: 0.0 A
Default unit: A
Manual operation: See "Bias Settings" on page 60
[SENSe:]MIXer:LOPower <Level>
This command specifies the LO level of the external mixer's LO port.
Parameters:
<Level> numeric value
Range:
13.0 dBm to 17.0 dBm
Increment: 0.1 dB
*RST:
15.5 dBm
Example: MIX:LOP 16.0dBm
Manual operation: See "LO Level" on page 59
[SENSe:]MIXer:SIGNal <State>
This command specifies whether automatic signal detection is active or not.
Note that automatic signal identification is only available for measurements that per-
form frequency sweeps (not in vector signal analysis or the I/Q Analyzer, for instance).
Parameters:
<State> OFF | ON | AUTO | ALL
OFF
No automatic signal detection is active.
ON
Automatic signal detection (Signal ID) is active.
AUTO
Automatic signal detection (Auto ID) is active.
ALL
Both automatic signal detection functions (Signal ID+Auto ID)
are active.
*RST:
OFF
Manual operation: See "Signal ID" on page 60
See "Auto ID" on page 60
Configuring the Measurement