Remote Control
R&S
®
FSPN
410
User Manual 1179.4363.02 ─ 01
11.7.2
Zoom
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:AREA
.................................................... 410
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>:AREA
...............................411
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>[:STATe]
............................ 412
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM[:STATe]
..................................................412
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:AREA
<x1>,<y1>,<x2>,<y2>
This command defines the zoom area.
To define a zoom area, you first have to turn the zoom on.
1 = origin of coordinate system (x1 = 0, y1 = 0)
2 = end point of system (x2 = 100, y2= 100)
3 = zoom area (e.g. x1 = 60, y1 = 30, x2 = 80, y2 = 75)
Suffix:
<n>
.
<w>
subwindow
Not supported by all applications
Parameters:
<x1>
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
<y1>
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
<x2>
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
Common Analysis and Display Functions
