R&S FSMR3000, User Manual

Page: 513 / 733

Remote Commands
R&S
®
FSMR3000
513 User Manual 1179.0116.02 ─ 02
Note that the corresponding trace must have a trace mode other than "Blank".
If necessary, the command activates the marker first.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Trace>
Example: //Assign marker to trace 1
CALC:MARK3:TRAC 2
Manual operation: See "Assigning the Marker to a Trace" on page 205
CALCulate<n>:MARKer<m>:X <Position>
This command moves a marker to a specific coordinate on the x-axis.
If necessary, the command activates the marker.
If the marker has been used as a delta marker, the command turns it into a normal
marker.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Position> Numeric value that defines the marker position on the x-axis.
The unit depends on the result display.
Range:
The range depends on the current x-axis range.
Default unit: Hz
Example: CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
Manual operation: See "Marker Table" on page 105
See "Marker Peak List" on page 105
See "Marker Position X-value" on page 204
12.6.4.2 General Marker Settings
The following commands control general marker functionality.
Remote commands exclusive to general marker functionality
DISPlay[:WINDow<n>]:MTABle
....................................................................................... 513
CALCulate<n>:MARKer<m>:X:SSIZe
.............................................................................. 514
DISPlay[:WINDow<n>]:MTABle <DisplayMode>
This command turns the marker table on and off.
Analyzing Measurements (Basics)