R&S FSMR3000, User Manual

Page: 224 / 733

Common Analysis and Display Functions
R&S
®
FSMR3000
224 User Manual 1179.0116.02 ─ 02
How to Copy Traces
1. A trace copy function is provided in a separate tab of the "Traces" dialog box. To
display this tab do one of the following:
● Select "Analysis" from the "Overview", then select the "Trace Copy" tab.
2. Select the "Source" trace to be copied.
3. Select the "Copy to Trace" button for the trace to which the settings are to be
applied.
The settings from the source trace are applied to the destination trace. The newly
configured trace (if not set to "Blank") is displayed after the next measurement.
8.4.2 Spectrograms
8.4.2.1 Spectrogram settings
Access : [TRACE] > "Spectrogram Config"
The individual settings available for spectrogram display are described here. For set-
tings on color mapping, see
"Color map settings" on page 226.
Settings concerning the frames and how they are handled during a measurement are
provided as additional sweep settings for spectrogram display.
● General spectrogram settings ...............................................................................224
● Color map settings ................................................................................................ 226
General spectrogram settings
Access : [TRACE] > "Spectrogram Config"
This section describes general settings for spectrogram display.
State ............................................................................................................................224
Select Frame ...............................................................................................................225
History Depth .............................................................................................................. 225
Time Stamp ................................................................................................................. 225
Color Mapping .............................................................................................................225
Continuous Sweep / Run Cont ....................................................................................225
Single Sweep / Run Single ..........................................................................................226
Clear Spectrogram ...................................................................................................... 226
State
Activates and deactivates a Spectrogram subwindow.
"Split" Displays the Spectrogram as a subwindow in the original result dis-
play.
"Full" Displays the Spectrogram in a subwindow in the full size of the origi-
nal result display.
"Off" Closes the Spectrogram subwindow.
Trace Configuration