R&S FSMR3000, User Manual, Page: 225 / 733

Common Analysis and Display Functions
R&S
®
FSMR3000
225 User Manual 1179.0116.02 ─ 02
Remote command:
CALCulate<n>:SPECtrogram:LAYout
on page 491
Select Frame
Selects a specific frame, loads the corresponding trace from the memory, and displays
it in the Spectrum window.
Note that activating a marker or changing the position of the active marker automati-
cally selects the frame that belongs to that marker.
This function is only available in single sweep mode or if the sweep is stopped, and
only if a spectrogram is selected.
The most recent frame is number 0, all previous frames have a negative number.
Remote command:
CALCulate<n>:SPECtrogram:FRAMe:SELect
on page 490
History Depth
Sets the number of frames that the R&S FSMR3 stores in its memory.
If the memory is full, the R&S FSMR3 deletes the oldest frames stored in the memory
and replaces them with the new data.
Remote command:
CALCulate<n>:SPECtrogram:HDEPth
on page 491
Time Stamp
Activates and deactivates the timestamp. The timestamp shows the system time while
the measurement is running. In single sweep mode or if the measurement is stopped,
the timestamp shows the time and date of the end of the measurement.
When active, the timestamp replaces the display of the frame number.
Remote command:
CALCulate<n>:SPECtrogram:TSTamp[:STATe]
on page 493
CALCulate<n>:SPECtrogram:TSTamp:DATA?
on page 492
Color Mapping
Opens the "Color Mapping" dialog.
Continuous Sweep / Run Cont
While the measurement is running, the "Continuous Sweep" softkey and the [RUN
CONT] key are highlighted. The running measurement can be aborted by selecting the
highlighted softkey or key again. The results are not deleted until a new measurement
is started.
Note: Sequencer. Furthermore, the [RUN CONT] key controls the Sequencer, not indi-
vidual sweeps. [RUN CONT] starts the Sequencer in continuous mode.
Remote command:
INITiate<n>:CONTinuous
on page 473
Trace Configuration