R&S FS300 Factory Settings
R&S FS300
E-1007.9900.15
6-74
Operating manual, 02/2006
6
Using the R&S FS300
This chapter
All the spectrum analyzer functions and their uses are fully described in chap-
ter 6. The order in which the menus are described follows that of the proce-
dures for configuring and starting measurements:
R&S FS300 default settings
Setting measurement parameters
Selecting and configuring measurement functions
Further
information
The operating concept is explained in chapter 5, which also contains an over-
view of the menus and functions.
The index at the end of this manual will also help you find the information you
want.
6.1
R&S FS300 Factory Settings
Switching on for the
first time
When you switch on the R&S FS300 ( 3-44), the settings you were using
when the instrument was last switched off are restored.
When you switch on for the first time, the factory default settings are acti-
vated:
Parameter Setting
Frequency axis
Center frequency (CENTER)
1.5 GHz
Frequency span (SPAN)
3 GHz
Step size for center frequency
150 MHz
Level axis
Reference level (REF LEVEL)
-20 dBm
Level offset (REF LEVEL OFFSET)
0 dB
Level range (RANGE)
80 dB
Level unit (UNIT)
dBm
RF input
Input attenuation (RF ATTEN)
AUTO (NORMAL)
Bandwidth
Sweep time (SWEEP TIME)
AUTO
Resolution bandwidth (RES BW)
AUTO (1 MHz)
Video bandwidth (VIDEO BW)
AUTO (1 MHz)
Frequency sweep
Sweep CONT
SWEEP
Trace
Trace CLEAR/WRITE
Trigger
Trigger FREE
RUN
Markers
Marker 1 and marker 2
OFF
NOTE
The factory default setting is stored in non-volatile memory in the R&S FS300
and can be reloaded at any time ( 6-153).
Summary of Contents for FS300
Page 1: ...2 2006...
Page 16: ......