Physiolaser
olympic 500
Version 1.4 June 2007
36
International plugs
As an optional accessory you can use various interchangeable plugs corresponding to
the international electric systems (Australia, USA, England, Europe).
New installation of the software, update
The front panel provides an opening for a memory card (SD format). By means of the
RJ-memory card you can install the main software or update the device.
I
1. Insert SD card
2. Turn the key to ON
3. Follow the instructions on the screen
Error messages
The following error messages can occur in case of internal demage or failure.
Device
Error message
Reason
What to do
Main Unit
"Insert SD-Card"
No SD-Card detected
(SD-Card may be defective)
Insert SD-Card
Single Probe "Laser 1 defect !"
Laserdiode defective
Press
"Start/Stop"
"Laser 1 Overload!"
Laserdiode 1 Overcurrent
Press
"Start/Stop"
Cluster
Probe:
"Laser x defect !"
Defekte Diode,
x = number of laserdiode
Press
"Start/Stop"
"Laser x Overload"
"A:nnn V:mmm "
Laser Overcurrent, x=number,
nnn and mmm are values
measured by the system
Press
"Start/Stop"
All systems
"E2prom Corrupted!"
Memory defective
" Contact
Service "
If an error message occurs, press „Start/Stop“.
If the error occures again after adjustment, contact your supplier or the RJ service
([email protected]).
