R&G LP0339BK, Fitting Instruction

Page: 8 / 27

Page 8 of 27
LP0339
on the OEM undertray unit (Labelled A in picture 12 and arrowed in
picture 13)
• Insert the two M6 x 15mm bolts (Item 2) with M6 washers (Item 3)
through the two holes located on the back of the subframe (Arrowed in
picture 13). Secure the assembly with M6 washer (Item 3) and M6
nyloc nut (Item 8) on each bolt. Do not fully tighten the nuts at this
stage. Please make sure that the wiring is positioned in the same
orientation as shown in picture 14.
•
Insert the two Spacers (Item 4) between the sub-frame and the
licence plate bracket assembly as orientated in picture 16. Insert an
M6 x 50mm bolt (Item 1) with M6 washer (Item 3) through the hole
where the spacer is aligned to on the sub-frame. Ensure the bolt is
gone through the spacer and the spacer is sandwiched between the
sub-frame and the licence plate bracket (item 7). Secure the assembly
with M6 washer (Item 3) and M6 nyloc nut (Item 8). Repeat the
procedure for the other M6 x 50mm bolt (Item 1).
•
Locate the wiring in the centre between the two spacers as shown in
picture 15.
•
Tighten the four nyloc nuts using suitable tools to ±15 Nm (Picture 16)
•
Reconnect all the indicator wiring plug sockets and check operation.
•
Connect the male connector of the taillight connector (Item 13) into
the OEM female connector in the main wiring loom.
•
OEM number plate connector light is no longer in use as the taillight
unit (Item 12) comes with built-in LED license plate lights.
•
Fit licence plate to the new licence plate bracket (item 7) (it may
require re-drilling).
•
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND
PLACING IT FAR DOWN ON THE LICENCE PLATE HANGER,
THERE IS A SMALL CHANCE OF THE LICENCE PLATE HITTING
THE BACK WHEEL UNDER HEAVY LOAD AND OVER LARGE
BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK
FOR THIS POSSIBILITY AND TAKE AVOIDING ACTION.
FAILURE TO CHECK THIS COULD RESULT IN SERIOUS INJURY.
•
Refit the Seat lock mechanism, tool holder and seat catch as original.
• Refit seat.
•
Depending on local laws, attach enclosed red reflector (item 18) in an
appropriate location.
Please test the indicators, rear light, no. plate light and brake
light before riding.