Page
6
of
21
LP0308
R&G
Unit
1
, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)
1
420 89007 Fax: +44 (0)
1
420 87301 www.rg-racing.com Email: [email protected]
FITTING INSTRUCTIONS
•
To fit the R&G tail tidy, remove the seat from the bike using the key under the tail unit as
shown in
Picture 1
.
•
Remove the 2 bolts also shown in
Picture 1
, using a 10mm socket or spanner.
•
Remove the 4 bolts shown in
Picture 2
using a 4 & 5mm Allen key.
•
The tail unit right-hand-side panel can now be removed from the tail unit in order to free the
cables to the indicators and rear light.
•
Next, Remove the 3 bolts shown in in
Picture 3
, to remove the fuse bracket and seat lock
mechanism plate.
•
Unplug the indicator and illuminator cables with a small screwdriver to free the connectors
shown in
Picture 4
.
•
The 4 nuts in
Picture 5
can now me removed, which frees the support bracket and bolts
holding the original license plate holder in place. Keep these 4 nuts safe as they will be re-used
on the R&G tail tidy.
•
Carefully remove the cables attached to the original license plate holder through the small hole
in the underside of the tail unit.
•
With the original license plate holder removed, you must first assemble the R&G tail tidy before
it can be attached.
•
Secure Item 2 (License plate mount plate) to Item 3 (Cover plate) using an M5 countersunk
screw. Tighten with an M5 washer and nyloc nut.
•
Next, attach Item 1 (Main bracket) to Item 2 (License plate mount plate) as shown in
Picture
8
, with the same M5 screws, washers and nuts shown in
Picture 9
.
•
If using the original indicators, these can be removed from the original license plate holder and
attached to the R&G tail tidy using the OEM indicator adaptors (Item 5)
•
If using R&G or other indicators, Item 4 (indicator adaptors) can be used to attach these.
•
Attach the License plate illuminator (Item 9) to the tail tidy through the holes shown in
Picture
10.
•
Attach the illuminator connector (left side of
Picture 4
) to the bullet connections on the R&G
illuminator wires. If using R&G or other indicators, attach the indicator connectors (right side of
Picture 4
) to the bullet connections on the indicator wires.
•
Route the indicator and illuminator wires through the centre of the tail tidy between the main
bracket and the cover plate until they are exposed at the main mounting area.