R&G Racing
Unit 1, Shelly’s Lane, East Worldham, Alton, Hampshire GU34 3AQ.
Tel: +44 (0)1420 89007 Fax +44 (0)1420 87301
www.rg-racing.com
Email:
PAGE 9 OF 24
LP0274
•
Using a 4mm allen key, remove the rubber indicator stem of each indicator by removing the cap
head bolt as in
picture 8
and remove the rubber stem from the indicator.
•
Feed the wire of the indicator through the indicator mount on the tail tidy bracket. To secure this,
cut a small slot into one mini indicator adapter (item 3) per side, and thread the wire through this
as shown in
pictures 9 & 10.
•
Slide the indicator adaptor against the inner face of the tail bracket and locate on the protrusions of
the indicator. Reuse the OEM cap head bolt to secure this using a 4mm allen key as shown in
picture 11.
•
Neatly route the wires using the provided cable ties (item 9) through the cable tie loops, leaving the
plastic OEM connectors on the top surface of the tail tidy as shown in
picture 12.
If using R&G Mini Indicators:
•
To fit the mini indicators, first use one piece of heat shrink (item 13) over each pair of wires and
heat this with a heat gun or similar until the wires are neatly wrapped.
•
Fit one Mini indicator spacer (item 6) over wire and thread of each mini indicator.
•
Thread one indicator fastening plate (item 3) over each pair of indicator wires with the wires
passing through the larger hole.
•
Thread each indicator assembly through each indicator mount on the tail tidy bracket (item 1).
•
Use the two remaining indicator fastening plates (item 3) to sandwich the indicator on the main tail
bracket as shown in
Assembly diagram 2
on page 3 and
picture 13
. It is recommended to use a
small amount of Loctite when fastening the flanged indicator nut to help keep the assembly tight.
•
To neaten the wiring, slide one indicator wiring cover (item 14) over the bullet connectors for each
indicator and slide up until the flanged nut is covered.
A small amount of lubricant or soap may help
when pushing the wires through the indicator wiring cover.
•
After fastening both indicators as seen in
picture 14
, use cable ties (item 9) to secure the exposed
wires to the top surface of the tail bracket as shown in
picture 12.
•
Fit one Mini CON15 indicator adaptor (item 11) to each mini indicator via bullet connectors to the
corresponding wire colours.
Fitting Tail Tidy to bike:
•
With both indicators and licence plate illuminator attached to the tail tidy, you should now connect
the OEM tail unit loom removed earlier to the indicator and licence plate light connectors, ensuring
that the indicators are connected to the corresponding side.
•
Route the licence plate illuminator wires from the underside up through the hole in the centre of the
tail tidy.
•
Neatly arrange the wires depending on your indicator choice using the self-adhesive cable clips
(item 15) keeping as much of the wiring as possible on the top surface of the tail tidy as this will
make them less visible when fixed to the bike.
•
Before fitting the tail tidy, connect the wiring loom to the motorcycle wiring loom as shown in
picture 15
and test all lights function correctly. If illumination fails, swap the bullet connectors
around.
