PAGE 8 OF 22
LP0273
R&G Racing
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire GU34 3AQ.
Tel: +44 (0)1420 89007 Fax +44 (0)1420 87301
www.rg-racing.com
Email:
FITTING INSTRUCTIONS
•
To fit the R&G tail tidy, remove the pillion seat using the key.
•
Underneath the pillion seat, disconnect the orange, blue and white connectors for the li-
cence plate illuminator light and two indicators, as shown in picture 1.
•
Remove the four bolts that mount the OEM licence plate hanger in place and support the
licence plate whilst feeding the wires out and removing from the bike, as shown in pictures 2,
3 & 4.
•
Remove the plastic undertray from the OEM licence plate hanger by removing the two
bolts that are positioned as arrowed in picture 5.
•
Remove the domed nut on either indicator, as arrowed in picture 6, and remove the metal
plate on the inside before feeding the indicator and wiring out through the hole, as shown in
picture 7.
•
Repeat the above procedure for the remaining indicator.
•
With the indicator removed, the rubber mount now needs to be pulled from the licence
plate hanger, as shown in picture 8.
The indicator and mounting parts removed are shown in picture 9, along with the domed nut.
•
Take the R&G mounting bracket (item 8 – TB0198 Part 1) and fit it to the R&G licence
plate bracket (item 2 – TB0198 Part 2) using the four M6 x 6mm button head bolts (item 6)
and four M6 washers (item 5), as shown in pictures 10 & 11, by fitting the bolts from behind
as shown.
•
Take the R&G licence plate illuminator (item 1 – LA0002) and fit the shroud using a small
amount of superglue, before fitting it to the licence plate bracket, as shown in picture 12, be-
fore fitting the washer and nuts on the rear and tightening. Fit one length of heatshrink to the
wires for protection.
•
Take both spacer plates (item 9 – TB0198 Part 3) and offer them into place on the top
mounting face of the tail tidy assembly, before locating the four M6 x 30mm long button head
bolts (item 7) through the mounting bracket and then through the four holes on the spacer
plates, as shown in picture 13.
•
Offer this assembly up to the underside of the tail and locate the four bolts through the
four mounting holes in the bodywork/subframe, before fitting one M6 washer (item 5) and
one M6 nyloc nut (item 10) to the exposed thread on each bolt, as shown in picture 15. Tight-
If fitting R&G Mini Indicators
•
To fit the R&G Mini Indicators, fit one length of heat shrink to the wires of each indicator.
•
Position two indicator adaptors (item 3 –I0031) onto the wiring of each indicator, ensuring
the sides facing each other have the raised centre profile, before fitting the flanged nut sup-
plied, as shown in picture 16.
Fit either indicator through the large slot on the either side of the tail tidy, locating the indica-
tor adaptors either side of the metal bracket, before fitting the nut onto the exposed thread
