4
Note: never use boiling liquids or run the appliance empty.
c) Replace the Top Cover on the jar and turn it clockwise, ensure that the Top Cover
can fix with the jar securely. If the Top Cover is not or is badly positioned, the blender
cannot be locked into place on the food processor and will not work.
d) You may add ingredient into the jar through the center opening of Top Cover during
operation, then replace Measuring Cup if necessary. Let the tab of Measuring Cup
aligns with the groove of Top Cover, put down and turn in anti-clockwise until the
measuring cup is fixed with the top cover.
Caution: While you are using coupler, i.e. when you use the blender, you must
leave the bowl into place, make sure that the lid is locked, if the lid is unlock,
the interlock switch is malfunction. The coupler will not operate. When using
the coupler, once plugging the power outlet, the spindle also is rotating, this is
normal, but never put food into the bowl. This may be damage the motor.
e) Connect the plug to wall outlet and set Speed Selector to your desired speed. The
detailed information of Speed Selector is as following figure 2.
f) The total operating time should not more than 3 minutes.
g) Turn the Speed Selector to 0 Position once the mixture has been blended to your
desired consistency.
h) Remove the jar from the Motor Unit (turning the jar anti-clockwise), carefully take
down the Top Cover, then pour and serve.
11
5
3
2
4
Fig.1
Fig.2
Pulse
Set and hold the pulse,
release the knob to stop
Stop
At any time, set the knob
to stop the appliance
High speed
Low speed
11
5
3
2
4
CLEANING
1.
Disconnect the power supply before cleaning.
2.
Pour a little warm water into the jar and turn the speed selector to P position for a
few seconds.
3.
Remove the jar and rinse and rinse under running water. Remove Top cover and
measuring cup, then immerse the top cover, measuring cup in water and clean them
with a soft brush, finally clean them with dump cloth.
Caution: the blade cannot be disassembled for cleaning.
4.
Wipe the outside of base with a damp cloth. Never immerse it in water as electric
shock is possible to occur. Then dry thoroughly. Ensure the interlock area is free of
food particles.