FM-100 Page 55
USING YOUR FM-100
•
Setting the frequency:
[1] Press both FREQ UP and FREQ DOWN at the same time. You should
hear a confirming low then high tone. The 10’s digit decimal point should
blink.
[2] Press and hold a FREQ button; the frequency should scroll through the
values.
[3] When frequency is acceptable, press both FREQ UP and FREQ DOWN.
You will hear three short quick beeps to let you know the data is written to
non-volatile memory.
•
Turning on the microphone:
[1] Make sure a microphone is plugged into the appropriate jack.
[2] Pre-set the gain level of the microphone before coming on the air. This will
prevent the audio level of your voice varying every time you come on.
[3] Use the MIC button to toggle between on and off.
•
Turning on AUTO AGC
[1] Press the AUTO AGC button, when the MIC ON LED is lit, it will blink rap-
idly to indicate AGC mode is selected.
[2] You can toggle this mode whether the MIC is on or off.
[3] Press the AUTO AGC button again to disable it.
•
Testing the display:
[1] Press both MIC and AUTO AGC at the same time.
[2] All of the display LEDs light to help you troubleshoot any display problems
[3] Press both keys again to return to normal mode.
•
Volume levels:
[1] Make sure music source peaks remain below +3dB. Any more level and
you introduce distortion.
[2] You should be able to set the microphone AGC once and leave it alone,
just using the MIC switch to turn it on and off.
