RAMSET FrameBoss pat003, Instruction Manual

Page: 7 / 28

Frame Boss
™
Instruction Manual
What to do if a
P.A. Tool Misfires
IF A TOOL MISFIrES, COnTInUE TO HOLD
THE TOOL AgAInST THE WOrK SUrFACE
FOr A MInIMUM OF 10 SECOnDS.
(Regulations in the UK require that the tool be
held against the work surface for a minimum of
30 seconds)
. After this time release the tool
from the work surface but continue to point the
fastener guide towards the work surface. Remove
the power load or power load strip as per normal
operation. If the power load strip can be removed
normally without any unusual effort or force;
return the power load or entire power load strip
to supplier/Ramset™
in a safe manner. If the
power load cannot be extracted from the tool in
the usual manner return the entire tool and power
load/s in an enclosed metal container. If a tool
misfires repeatedly over consecutive power load
strips, then the tool should be returned for service
with the power load strip immediately.
What to do if the strip
is not indexing
consistently
Return tool to Ramset™ immediately for
inspection/service.
In these circumstances NEVER send these items
through the post.
What to do if a
P.A. Tool Jams
In the event that a tool becomes jammed, (which
can be identified by the barrel remaining in the
most rearward position even when the tool is
removed from the work surface). This situation is
also evident by the fastener guide not protruding
from the front of the tool. The following steps
should be taken.
If the power load enclosed by the barrel has
been detonated then an attempt may be made to
release the barrel as described in the section of
this booklet entitled “Tool Maintenance”. If this is
not successful then the tool should be returned to
Ramset™
in the manner stipulated below.
If the power load enclosed by the barrel has
NOT been detonated then it is important that
no attempt be made to cycle the tool. Extreme
care should be taken where the tool is pointing
and hands should be kept well clear of the front
section of the tool. Return the entire tool and
power load/s in an enclosed metal container to
supplier/Ramset™.
In these circumstances NEVER send these items
through the post.
5