Rx-URME-031 Rev -
- DRAFT -
PMC551 Hardware Reference and Installation Manual
Page 4
2
HARDWARE INSTALLATION
2.1
Introduction
This chapter provides unpacking, hardware preparation and installation procedures for the
PMC551 module.
2.2
Unpacking Instructions
RAMiX boards are protected by an anti-static envelope and/or wrapping. Observe anti-static
precautions and work at an approved anti-static workstation when unpacking the board
Note:
The PMC551 is shipped in an individual, reusable shipping box. When you receive the shipping
container, inspect it for any evidence of physical damage. If the container is damaged, request
that the carrier’s agent be present during unpacking and inspection of the unit.
Unpack the PMC551 module from shipping carton. Check and verify that all items are present by
referring to the packing list.
2.2.1
Included Items
Each PMC551 is shipped with the following items:
•
PMC551 PMC Assembly
2.3
Handling
Electronic assemblies use devices that are sensitive to static discharge; this applies to both the
PMC551 and the host board onto which it will be mounted. Observe anti-static procedures when
handling these boards. The PMC551 should be in an anti-static plastic bag or conductive foam for
storage or shipment.
2.4
PMC551 INSTALLATION
The PMC551
Module is now ready for installation. Turn all system power off. Remove the host
board from the chassis (if currently installed). Locate the PMC connectors on the host board.
Carefully plug the PMC551
into the mating connectors on the host's printed circuit board. Be sure
module is seated properly into CMC connectors on the host. Use screws to fasten module into
host PCB.