17
Then Check the tires for proper air pressure, the minimum and maximum air pressure should be between
10psi-25psi.
Once the bike is assembled, fully charge the battery, and install the battery into the bike frame, being sure to
insert the key and turn clockwise to open the battery latching system.
OPERATING INSTRUCTIONS
Before operating be sure the rider can keep balance by testing the bike without using the motor to ensure the
rider is capable.
Be sure the seat height is set properly; the rider should be able to put both feet on the ground while fully
seated. The seat post has a minimum insertion point, be sure not to extend the seat beyond this line.
When using the bike for the first time, be sure to practice in a safe environment with no obstacles or hazards.
ALWAYS WEAR AN ASTM OR CPSC CERTIFIED HELMET AND PROTECTIVE ATTIRE INCLUDING SHOES
THROTTLE OPERATION
Your bike is equipped with a thumb throttle; the throttle can be used from a complete stop all the way to the
top speed and at any time. The thumb throttle is activated when the pedal assist level is on level 1-5. The
throttle will not work on level 0.
SHIFTING
Your bike is equipped with an Enviolo rear hub, the indicator will range from flat ground to a steep hill. The flat
ground will give you the most speed and least amount of torque. While the steep hill will give you the most
torque and the least amount of speed.
LCD INFORMATION
Below is a picture of the LCD on your bike, note that when the pedal assist level is on 0 there is no power from
the motor for both pedaling and for using the thumb throttle. Once the assist level is set above 0 the motor
will have power and pedal assist and the thumb throttle will be activated. Note that once you come to a
complete stop the LCD will reset the pedal assist level to 0 after 15 seconds, this is a built-in safety feature to
ensure safety.