2. Programming (cont.)
To add a device
to RG43 memory, just trigger an alarm from the
device you want to add. The indication LED for the device type will
turn on to indicate the memory slot now contains this device type
(Call, Pad, or Sensor). Multiple devices can be added to the same
memory slot. Adding a wireless reset button to a memory slot will
allow the button to reset of any active alarm in this slot.
To delete a device
from RG43 memory, select the memory slot
and hold RESET for ~5s. You should see the indication LED turn off
to indicate the device is no longer present in memory.
2.3 Auto-Programming
The RG43 panel now supports auto-programming when used
together with an RG2 Companion Wireless Monitor.
RG2 Companion Wireless Monitor must be set to t=2 or t=3 for
this to work.
On the
RG2
:
• Press P PAUSE for ~2s
• For t=2, use PAUSE to adjust tens digit and RESET to adjust the
units if the monitor will be moved to a new room
• For t=3, the display settings cannot be adjusted, and the
monitor will display [AP] to indicate it is ready for auto-pairing.
• Take the monitor next to the RG43 panel to synchronise the
displays.
On
RG43
:
• Hold P REVIEW for ~5s to enter pairing mode
• The RG43 will briefly display [AP], and all devices paired with the
RG2 monitor will be uploaded to the panel.
• The panel will indicate the number of devices that are received
from the RG2 monitor, followed by the new display ID or IDs.
Example 1. If an RG2 monitor with a bed and chair sensor programmed in and are set to t=2, then is uploaded with
new display [34], the RG43 panel will first show [d2] to indicate that two devices are paired into this display, followed
by [34] to confirm what will now display when a device is triggered.
Example 2. If an RG2 monitor set to t=3 with two bed sensors programmed to displays [34] and [35], the
RG43 will first show [d2] to indicate that two devices are being paired, followed by [34], [35] to confirm
what will now display when these devices are triggered.
