RAMATTI VENUS Comfort, Instruction Manual

Page: 11 / 38

10
– fig. –
2
. The clamp is secured after you hear the
click
. When a child is sitting in the safe-
ty seat, you must frequently check whether the clamp is still secured. To open the clamp, press
the red button located on the clamp.
III.2 Adjustment of the length of harnesses
In order to better protect your child, after you fix it in the safety seat and lock the clamp, you
should tighten the harnesses so they are snug and flat against the child's body. They should
never be twisted or loose. The hip strap should be placed as low as possible to restrain rigid-
ly the child’s pelvis. To tighten the harnesses press the colourful button located on the lock
between the child's legs –
fig. –
1
and at the same time pull the harness coming out from
the lock with your other hand – fig. –
2
.
To lengthen the harnesses press the colourful button located on the lock between the child's
legs –
fig. –
1
and pull the two harnesses simultaneously in your direction with your other
hand – fig. –
3
. When doing this, hold the harnesses, not their protective cover.
III.3 Adjusting the lenght of the shoulder straps
The shoulder straps can be set in 3 positions according to the child’s size. The height of straps
should be adapted to the child’s size, so that the child’s shoulders are at the same level as the
straps coming out the backrest –
fig. .
III.4 Changing the height of the shoulder straps
To change the height of the shoulder straps:
•
remove the shoulder straps from the fastener located on the rear part of the restraints – fig.
–
1
;
•
put the straps through the holes in the restraints to the front of the seat – fig. –
1
;
•
remove the shoulder straps from the guards – fig. –
1
;
•
relocate the straps’ guards to the rear of the backrest – fig. , and then through the holes
to the front of the backrest at the required level – fig. ;
•
pull the shoulder straps through the guards – fig. –
2
;
•
pull the shoulder straps through the holes in the restraints at the required level;
•
put the shoulder straps to the fastener – fig. –
2
. Otherwise, the shoulder straps will not
meet the safety requirements.
IV. MAINTENANCE AND REMOVAL OF THE SAFETY SEAT COVER
IV.1 Removing the seat cover
In order to remove the child seat cover, perform the following actions:
•
remove the shoulder belts from the belt clip located behind the child seat – fig. ;
•
insert the shoulder belts through openings in the child seat towards the front of the seat –
fig. and fig. –
4
;
•
remove the belt tips, plastic safety mechanisms located on the left and right sides of the
seat –
fig. –
1
and
2
;
•
pull the tips through the lower side openings of the seat – fig. –
3
;
•
unfasten the cover from snaps located beneath the arm rests of the seat – fig.
&
;
25 24
23
23
23 22
21
18
18
20
19
18
17
16
15
14
14
14
14
13
ENGLISH