Driver One Memory Position Recall
• To recall the memory settings for driver one using the memory switch, push
MEMORY button number 1 on the memory switch.
• To recall the memory settings for driver one using the RKE Key Fob, push the
UNLOCK button on the RKE Key Fob linked to memory position 1.
Driver Two Memory Position Recall
• To recall the memory setting for driver two using the memory switch, push
MEMORY button number 2 on the memory switch.
• To recall the memory settings for driver two using the RKE Key Fob, push the
UNLOCK button on the RKE Key Fob linked to memory position 2.
A recall can be cancelled by pushing any of the MEMORY buttons during a recall (S, 1,
or 2). When a recall is cancelled, the driver's seat, and the power pedals (if equipped)
stop moving. A delay of one second will occur before another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat positioning to enhance driver mobility
when entering and exiting the vehicle.
The distance the driver seat moves depends on where you have the driver seat
positioned when you remove the Key Fob from the ignition (or change the ignition to
OFF, for vehicles equipped with Keyless Enter-N-Go).
• When you remove the Key Fob from the ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-Go), the driver seat will move about
2.4 inches (60 mm) rearward if the driver seat position is greater than or equal to
2.7 inches (67.7 mm) forward of the rear stop. The seat will return to its previously
set position when you place the ignition into the ACC or RUN position.
• When you remove the Key Fob from the ignition (or change the ignition to OFF, for vehicles
equipped with Keyless Enter-N-Go), the driver seat will move to a position 0.3 inches
(7.7 mm) forward of the rear stop if the driver seat position is between 0.9 inches and
2.7 inches (22.7 mm and 67.7 mm) forward of the rear stop. The seat will return to its
previously set position when you place the ignition to the ACC or RUN position.
• The Easy Entry/Easy Exit feature is disabled when the driver seat position is less
than 0.9 inches (22.7 mm) forward of the rear stop. At this position, there is no
benefit to the driver by moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an associated Easy Entry and Easy Exit
position.
NOTE:
The Easy Entry/Exit feature is not enabled when the vehicle is delivered from the
factory. The Easy Entry/Exit feature is enabled (or later disabled) through the
programmable features in the Uconnect system. Refer to “Uconnect Settings/
Customer Programmable Features” in “Understanding Your Instrument Panel” in the
Owner’s Manual on the DVD for further information.
G E T T I N G S T A R T E D
34
Summary of Contents for Chassis CAB 4500 2016
Page 226: ...NOTES 224...
