RAM 2010 TRUCK 3500, User Manual

Page: 74 / 96

FUEL FILTER/WATER SEPARATOR — DIESEL ONLY
Draining Fuel/Water Separator
• If the “Water in Fuel” indicator light is illuminated and an audible chime is heard
five times, you should stop the engine and drain the water from the separator.
• The drain is located on the bottom of the Fuel Filter and Water Separator assembly
which is located on the drivers side of the engine.
• Turn the drain valve (located on the side of the filter) counterclockwise 1/4 turn, then
turn the ignition switch to the ON position to allow any accumulated water to drain.
• When clean fuel is visible, close the drain and switch the ignition to OFF.
• Refer to the Owner's Manual on the DVD for further details.
CAUTION!
• If the “Water In Fuel Indicator Light” remains on, DO NOT START the engine before
you drain water from the fuel filter to avoid engine damage.
• Do not drain the fuel/water separator filter when the engine is running.
• Diesel fuel will damage blacktop paving surfaces. Drain the filter into an
appropriate container.
Fuel Filter Replacement — Diesel Only
• With the engine off and a drain pan under the fuel filter drain hose, open the water
drain valve 1/4 turn counterclockwise and completely drain fuel and water into the
approved container.
• Close the water drain valve and remove the lid using a socket or strap wrench; rotate
counterclockwise for removal. Remove the used o-ring and discard it.
• Remove the used filter cartridge from the housing and dispose of according to your
local regulations.
• Wipe clean the sealing surfaces of the lid and housing and install the new o-ring into
ring groove on the filter housing and lubricate with clean engine oil.
• Install a new filter in the housing. Push down on the cartridge to ensure it is properly
seated.
Do not pre-fill the filter housing with fuel.
• Install the lid onto the housing and tighten to 22.5 ft lbs (30.5 Nm). Do not overtighten
the lid.
• Start the engine and confirm no leaks are present.
CAUTION!
• Diesel fuel will damage blacktop paving surfaces. Drain the filter into an
appropriate container.
• Do not prefill the fuel filter when installing a new fuel filter. There is a possibility
debris could be introduced into the fuel filter during this action. It is best to install
the filter dry and allow the in-tank lift pump to prime the fuel system.
MAINTAINING YOUR VEHICLE
72