312
SERVICING AND MAINTENANCE
REAR TAIL / STOP, TURN SIGNAL AND BACKUP
LAMPS
See below steps to replace.
1. Remove the two screws that pass through the
bed sheet metal.
Tail Lamp Screw Locations
2. Pull the outboard side of the lamp rearward far
enough to unsnap the two receptacles on the
outboard side of the lamp housing from the
two plastic snap post retainers in the outer box
side panel.
Pulling Out The Tail Lamp
3. Disconnect the wiring harness connectors
from the bulb socket.
4. Rotate the bulb socket counterclockwise a
quarter turn to unlock it from the housing.
Wiring Harness Connector
5. Pull the bulb straight out of the socket.
22_DS_OM_EN_USC_t.book Page 312
Summary of Contents for 1500 CLASSIC 2022
Page 90: ...88 GETTING TO KNOW YOUR INSTRUMENT PANEL BASE INSTRUMENTCLUSTER 22_DS_OM_EN_USC_t book Page 88...
Page 360: ......
Page 361: ......
Page 362: ......