3.
Using a craft knife cut a gap in the trace that connects the two “external mute”
pads.
4.
Prepare a 24” #22 black/black twisted pair.
•
Connect the two wires to the two “external mute” pads.
————————————————————————————
The “Input Select” pads are not used.
The “From RAKK dac” pads are not used.
————————————————————————————
Pre
wire
the
RAKK
Input
The length of the wires between the Active Output and RAKK Input will vary depending on the
number of inputs on the RAKK Input board. The lengths here are the maximum expected and
may be too long for your unit. Trim them to the correct length when you attach the other ends.
Wire the Outputs on the RAKK Input board
5.
Prepare a
17” #22 blue/black twisted pair.
•
Connect the blue wire to the left “OUT +” pad.
•
Connect the black wire to the left “OUT -” pad.
6.
Prepare a 12” #22 orange/black twisted pair.
•
Connect the orange wire to the right “OUT +” pad.
•
Connect the black wire to the right “OUT -” pad.
————————————————————————————
Wire the 12V on the RAKK Input board
7.
Prepare a 13½” #20 yellow wire and connect it to the 12V pad.
————————————————————————————
7
