Panel
Assembly
Bottom
Panel
Assembly
Steps preceded by a “note” (
♪
) deal with components which must be oriented properly.
TIP – To ease the alignment of the mounting holes with standoffs, slightly loosen the standoffs
from the board, install the screws through the bottom panel into the standoffs and then re-tighten
the standoffs.
————————————————————————————
♪
Mount the power transformer
1.
Mount the LL1683 transformer in its location using the four 4mm metric screws. Orient the
transformer such that the high-voltage (shorter) pins are towards the front of the panel. The
front of the panel has the lip.
•
Dress the white/black twisted pair toward the edge of the panel. Then the white/black
twisted pair will go towards the rear of the panel and the black/black twisted pair will go
to the front of the panel.
•
Dress the black twisted pair for the power indicator toward the front of the panel.
•
Dress the grey twisted pair that will power the filaments toward the center of the panel.
•
Dress the red/red/black twisted trio toward the center of the panel.
13
