2021 RALE® ST120 INSTALLATION GUIDE
16
DANGER
To avoid serious injury or death: prevent objects, clothing, or
extremities from becoming entangled or jammed in and around
moving parts. IMMEDIATELY STOP THE ENGINE AND ENGAGE
THE BRAKE IF THIS CAN OR DOES OCCUR.
CAUTION
Proper track tension and alignment are important to the
operation and wear of the RALE Track Kit.
1. Raise and securely position the bike until the track kit is FULLY
SUSPENDED.
2. The adjustment screws at the rear bogie wheels adjust the track
alignment and tension.
3. Start the host bike in neutral. While idling, put the bike in gear to
engage the RALE Track Kit and let it spin for 15-30 seconds.
4. STOP the RALE Track and TURN OFF the engine.
5. Check for even alignment along edge of the hyfax compared to
the track.
6. Tighten and/or loosen the left or right side track adjustment
screws 1 to 2 turns depending on the necessary adjustment.
7. Repeat steps 3 - 6 until the track is aligned.
8. Tighten or loosen both sides of the rear axle equally until there is
3/4” to 1” of slack between the track and the hyfax.
9. Tighten the nuts to lock each adjustment screw into position.
10. Torque the track kit rear axle bolts to 50 FT/LB
S
e T T i n g
T
r a c k
a
l i g n m e n T
